wave.com Zn
divergence.com .5
tuneup.com

after tuneup  press "Update" in bluice "Collect" TAB to read in correct Energy for Zn

Find a crystal that diffracts well
run index
get a stragey
use the recommended Starting Phi angle  and set total data collect range to be 180 degrees of data
Click on Inverse beam
 
(Remember to Collect into a New Subdirectory!)

Press the "SCAN" Tab and Run a MAD Scan at the Zn-K edge
  when the scan is done, if successful, it will list 3 energies:
    Inflecion, Peak, and Remote
  Compute the arithmetic Mean Energy of the Peak and Inflection Engergies  (Peak + Inflection)/2

In Collect Tab Press "Update" to read in the 3 energies you got from the MAD Scan
   Delete either the peak or the inflection engery then enter the Mean Engery into the Energy you did NOT delete
   You should now have 2 energies Mean and Remote 

Make the Wedge size 30 degrees

run  "exposure_time.com" to calculate the allowable exposure time for each frame.
  Do NOT take the defalt of NOT measuring the flux, i.e. enter "y" or "yes", then move crystal out of the way and press enter.
  If you do NOT have an expousre of at least 0.2 seconds per frame, then you need to attenuate more!
     Try "divergence.com .35"  and run again
     If that doesn't attenuate enough try  "divergence.com .25 .25"
     If that doesn't attenuate enough try to Reduce the total number of frames by decreasing the oscillation angle.
       Then run "exposure_time.com" again

When you get an acceptable exposure time -- one Greater Than or Equal to 0.2 seconds -- put that into "Time" in the RUN_1 in the Collection Tab and
  START DATA COLLECTION.

Good Luck